3A, 55V, White LED Driver Suitable for Step-Down with Current Mode Operation
The MP24833-A is a 55V, 3A, white LED driver suitable for step-down, inverting step‑up/step-down, and step-up applications. The MP24833-A achieves 3A of output current with excellent load and line regulation over a wide input supply range.
Current mode operation provides a fast transient response and eases loop stabilization. Full protection features include thermal shutdown, cyclebycycle peak current limiting, open-string protection, and output short-circuit protection (SCP).
The MP24833-A incorporates both DC and PWM dimming into a single control pin. The separate input reference ground pin allows for direct enable and/or dimming control for a positive-to-negative power conversion.
The MP24833-A requires a minimal number of readily available, standard, external components and is available in a SOIC-8 EP package.
- 3A Maximum Output Current
- Unique Step-Up/Step-Down Operation (Buck-Boost Mode)
- Wide 4.5V-to-55V Operating Input Range for Step-Down Applications (Buck Mode)
- 0.15O Internal Power MOSFET Switch
- Fixed 210kHz Switching Frequency
- Analog and PWM Dimming
- 0.2V Reference Voltage
- 6µA Shutdown Mode
- No Minimum Number of LEDs Required
- Stable with Low ESR Output Ceramic Capacitors
- Cycle-by-Cycle Over-Current Protection (OCP)
- Thermal Shutdown Protection
- Open-String Protection
- Output Short-Circuit Protection (SCP)
- Available in a SOIC-8 EP Package
- Vin (max) (V)55
- Vout (max) (V)55
- Iout (max) (A)3
- Open LED ProtectionYes
- Rds(on) (mΩ)150
- TypeBuck-Boost, Buck, Boost
- Vfb (V)0.198
- fsw (max) (kHz)210
- Iq (mA)0.6
- Ishutdown (µA)6
3A, 55V White LED Driver
The EV24833-A-N-00AEvaluation Board is designed to demonstrate the capabilities of MP24833-A. The MP24833-A is a 55V, 3A, white LED driver suitable for either step-down or inverting step‑up/down applications.
EV24833-A-N-00A is compatible with step-down (Buck) and inverting step-up/down (Buck-boost) applications.
- For step-down application, short “JP1”, open “JP2”, connect LED load to “LED+” and “LED-”
- For step-up/down application, short “JP2”, open “JP1”, connect LED load to “LED+” and “LED-”
￥ 175.50 + tax