3.3V, 1A-3A Programmable Current Limit Switch with Auto Enable

  • 数量 单价
  • 1
    ¥ 0.07 /unit


Arrives 3-4 business days.
Shipping only $5 per order.



The MP5003 is a protection device designed to protect circuitry on the output (VOUT) from transients on the input (VIN). It also protects VIN from undesired shorts and transients coming from the load. At start up, inrush current is limited by limiting the slew rate at VOUT. The slew rate is controlled by a small capacitor at the dv/dt pin. The dv/dt pin has an internal circuit that allows the customer to float this pin (no connect) and still receives a 1.4ms ramp time at VOUT. The max load at the output (VOUT) is current limited. This is accomplished by utilizing a sense FET topology. The magnitude of the current limit is controlled by an external resistor connected between the ILIMIT pins. An internal charge pump drives the gate of the power device, allowing a very low on-resistance DMOS power FET of just 56mO. VOUT is protected from VIN being too low or too high. Under Voltage Lockout (UVLO) assures that the input is above the minimum operating threshold, before the power device is turned on. If VIN goes above the high output threshold, the output voltage will be limited.


  • Integrated 56mO Power FET
  • Enable/Fault Pin
  • Adjustable Slew Rate for Output Voltage
  • Adjustable Current Limit: 1A-3A
  • Automatic Startup/Retry after Thermal Protection
  • Over-Voltage Limit


  • EnableActive High
  • Fault FlagThermal Fault = Tri-State
  • Ilimit (A)Prog.
  • Slew Rate ControlYes
  • Rds(on) (mΩ)44
  • GradeCatalog
  • PackageQFN-10 (3x3)
  • Channels1
  • Iq (typ) (µA)1500
  • Iout (max) (A)3
  • Vin (max) (V)6
  • 最小输入电压2.5